|
Who's Online
There currently are 5914 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Exactly what was needed to assess the product - excellent value and great service
;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
Exchange of LBE, LBF board
1 2 3
(Photo 1)
(Photo 2) 1. Remove the screws in order of 1-3-2 from heat sink and then get rid of heat sink. (Photo 1) 2. Remove the TPC, FFC and power cable from the connectors. 3. Remove all of the screws from defected board. 4. Remove the defected board. 5. Replace the new board and then screw tightly. 6. Get rid of the foreign material from the connector. 7. Connect the TCP, FFC and power cable to the connector. 8. Reassemble the TCP heat sink. 9. Screw in order of 2-1-3. (Photo 2) If you screw too tightly, it is possible to get damage on the Driver IC of TCP.
Exchange YB and YM board
1. Separate all of the FPC connector of YB. (Photo 1) 2. Loosen all of the screws of YB and YM. 3. Remove the board from chassis. 4. Remove the connector of CN5004, CN5011, CN5012 among YB and YM. 5. Remove the YB from Y-main.
2-4-5
PZ3PDMDA
|
|
|
> |
|